求救怎麼解決故障碼，FZ6N-S2-ABS故障碼12，30，46 。

[leo540]

想說騎車的天氣來了，就先檢查一下車的狀態，好奇叫了故障碼出來，"嚇" 出現了
12"， 30"， 46" 。
完全沒有遇過不知道要怎麼解決問題?((有辦法自行處理嗎?有人可教嗎?))
若沒有辦法，桃竹地區那兒可解決問題。
感謝大家的幫忙 !!
_________________
FZ6N-S2-ABS 新手駕駛請大家多多指教囉!

[handsomefatty]

故障碼讀取模式:
儀表開電門前把引擎熄火開關設定成熄火，
按住 Select + Reset 不放，
電門打開後，約八秒後，
儀表會秀出 d1 的字樣，
再按住 Select + Reset 不放，
自動會跳到檢測模式及故障碼顯示。


診斷碼
01: 節氣閥角度 - 0 ~ 125度, 全關位置(15 ~ 16), 全開位置(97 ~ 102)
03: 氣壓差 (大氣壓力 減 吸氣壓力) - 0 ~ 126kPa
05: 吸氣溫度
06: 水箱水溫
07: 車速感應器脈衝記錄 - 0 ~ 999 (過 999 會返 0)
08: 傾倒熄火感應器 : 垂直:0.4 ~ 1.4V, 傾倒:3.8 ~ 4.2V
09: 燃料系統電壓 - 0 ~ 18.7V (正常12.0V)
20: 側架開關 - 側架下: OFF, 側架上: ON
21: on/off?
30: 點火線圈 - 熄火開關由 "關" 去 "開" 1 秒後會點火 5 次, 然後引擎故障燈會亮
31: 噴嘴?
36: 噴嘴(#1) - 熄火開關由 "關" 去 "開" 1 秒後會作動 5 次 (會聽到 5 下聲, 然後引擎故障燈會亮)
37: 噴嘴(#2) - 熄火開關由 "關" 去 "開" 1 秒後會作動 5 次 (會聽到 5 下聲, 然後引擎故障燈會亮)
48: ?
50: 噴射 Relay - 熄火開關由 "關" 去 "開" 1 秒後會作動 5 次 (會聽到 5 下聲, 然後引擎故障燈會亮)
51: 水箱風扇 Relay - 熄火開關由 "關" 去 "開" 1 秒後會開 5 次 (然後引擎故障燈會亮 2 秒, 熄 3 秒)
52: 大燈 Relay - 熄火開關由 "關" 去 "開" 1 秒後會開 5 次 (然後引擎故障燈會亮 2 秒, 熄 3 秒)
57: 暖手器 Relay - 熄火開關由 "關" 去 "開" 1 秒後會開
60: EEPROM　故障碼顯示 - 01 ~ 02, 00 表示正常
61: 故障碼顯示 , 00 表示正常, 如果多過一個故障碼會隔 2 秒顯示下一個
62: 故障碼記錄總數 - 00 ~ 17, 00 表示正常, - 熄火開關由 "關" 去 "開" 會 reset
63: ?
70: Control Number - 00 ~ 255

注意!!30,31,36,37,48,63有待查證..不清楚診斷項目...以上參考重論T-MAX車友提供的資料

進入診斷系統各代號代表的涵義:
01 - Throttle position sensor signal
02 - Atmospheric pressure Displays the atmospheric
03 - Intake air pressure Displays the cylinder-#1
05 - Intake air temperature Displays the intake air temperature.
06 - Coolant temperature Displays the coolant temperature.
07 - Vehicle speed pulse 0–999 Check that the number
08 - Lean angle sensor Remove the lean angle
09 - Fuel system voltage
20 - Sidestand switch Set ON/OFF the sidestand
21 - Neutral switch Set ON/OFF the neutral
30 - Cylinder-#1 ignition coil Actuates the cylinder-#1 ignition
31 - Cylinder-#2 ignition coil Actuates the cylinder-#2 ignition
32 - Cylinder-#3 ignition coil Actuates the cylinder-#3 ignition
33 - Cylinder-#4 ignition coil Actuates the cylinder-#4 ignition
36 - Injector #1 Actuates the injector #1 five
37 - Injector #2 Actuates the injector #2 five
38 - Injector #3 Actuates the injector #3 five
39 - Injector #4 Actuates the injector #4 five
48 - Air induction system solenoid
50 - Fuel injection system relay Actuates the fuel injection
51 - Radiator fan motor relay Actuates the radiator fan
52 - Headlight relay Actuates the headlight relay
53 - Exup servo motor Actuate the servo motor turns
56 - Sub-throttle servo motor Actuate the servo motor turns
60 - EEPROM fault cylinder No
61 - Malfunction history code
62 - Malfunction history code
63 - Malfunction code reinstate

And here are the ECU error codes故障碼對照表

11 - Cylinder identification sensor
12 - Crankshaft position sensor
13 - Intake air pressure sensor
14 - Intake air pressure sensor hose line
15 - Throttle position sensor (open or short circuit)
16 - Throttle position sensor (stuck)
17 - EXUP servo motor potention circuit
18 - EXUP servo motor (stuck)
19 - Sidestand switch (open circuit in the
20 - Intake air pressure sensor or atmospheric
21 - Coolant temperature sensor
22 - Intake air temperature sensor
23 - Atmospheric pressure sensor
24 - O2 sensor No normal signal is received from the O2 sensor.
30 - Lean angle sensor (latch up detected)
33 - Cylinder-#1 ignition coil
34 - Cylinder-#2 ignition coil
35 - Cylinder-#3 ignition coil
36 - Cylinder-#4 ignition coil
39 - Injector (open circuit)
41 - Lean angle sensor (open or short-circuit)
42 - Speed sensor No normal signals are received from the speed sensor.
43 - Fuel system voltage (monitoring voltage)
44 - Error in writing the amount of CO adjustment
46 - Vehicle system power supply
47 - Sub-throttle servo motor potention (open
48 - Monitor the operation of the sensors and
48 - Sub-throttle servo motor (lock)
50 - ECU internal malfunction (memory check error)

[leo540]

謝謝大大~
故障碼~已解決了~
萬分感謝
^0^
_________________
FZ6N-S2-ABS 新手駕駛請大家多多指教囉!